RFC - 4798
Connecting IPv6 Islands over IPv4 MPLS Using IPv6 Provider Edge Routers (6PE)
| Original: | ftp://ftp.isi.edu/in-notes/rfc4798.txt |
|---|---|
| Authors: | J. De Clercq [Alcatel-Lucent], D. Ooms [OneSparrow], S. Prevost [BT], F. Le Faucheur [Cisco] |
| Date: | February 2007 |
| Category: | Proposed Standard |
| Referred by: | 1 RFC |
| Refers to: | 16 RFC |
Status
This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The IETF Trust (2007).
Abstract
This document explains how to interconnect IPv6 islands over a Multiprotocol Label Switching (MPLS)-enabled IPv4 cloud. This approach relies on IPv6 Provider Edge routers (6PE), which are Dual Stack in order to connect to IPv6 islands and to the MPLS core, which is only required to run IPv4 MPLS. The 6PE routers exchange the IPv6 reachability information transparently over the core using the Multiprotocol Border Gateway Protocol (MP-BGP) over IPv4. In doing so, the BGP Next Hop field is used to convey the IPv4 address of the 6PE router so that dynamically established IPv4-signaled MPLS Label Switched Paths (LSPs) can be used without explicit tunnel configuration.
-
prepared by Miloslav Nic
- the founder of Zvon.org and Law-Ref.org
- the head of B.Sc. program Informatics and chemistry [in Czech]
- the founder of Lidem.org - Volby 2006 - parliamentary elections in the Czech Republic [in Czech]
- the chief consultant of the publishing house ICT Press
- and Pavel Srb, a student of B.Sc. program Informatics and chemistry